Dillon Precision RL-550B Progressive Reloading Machine

dillon-precision.jpg

In the early ‘70’s I started shooting more frequently and decided to reload my own ammo. I purchased an RCBS reloading press and a powder measure and a scale and a lot of other stuff that was needed to reload my .45ACP ammo. The major fallback was that each and every round had to be resized and de-primed (using the first of three dies); then they all had to be re-primed (installing new primers); then, after adjusting the powder measure to the correct charge of powder, I had to dump the powder into each individual cartridge. After that, I would take a new bullet and put it on each cartridge and using the press with the third die installed, I would seat the bullet and crimp the case. It took about 3 hours to reload 100 rounds. But, that was the way it was done.

In the early ‘80’s I became aware of a device called a “progressive reloading machine”. There were a few on the market, but with a little research, I found that one was being manufactured by Dillon Precision in Scottsdale, AZ. At that time I lived in Phoenix, so I went over to see this device. As I walked in to the showroom, I must say that I was very impressed both by the overall view and by the attention that I received from the salesperson. I was showed how easy that reloading COULD be, and the saving of major amounts of labor hours. Naturally, I became an owner of a brand new RL-550 Progressive reloading press.

They tell me that a guy can reload 500 rounds an hour with this machine. I have only done about 350 per hour but never broke out into a sweat! The fascinating thing about this reloading press is that once you get started, you drop a loaded round with every pull of the handle. Not 5 pulls and two die changes for every round as before.

After a few years of trouble-free operation, I had a problem with the automatic primer feed. I took the machine over to Scottsdale, and they told me that they had seen this problem before and that there was an upgrade that could be done to my machine. At that point I asked how much it would cost to upgrade to the “next level” (RL-550B). I was told that they [Dillon Precision] have a “NO B.S. Lifetime Warranty” and it would cost me nothing to upgrade my machine to the RL-550B Specs. Mind you, I had been using this press for over 13 years!

You just do not find that kind of commitment from very many companies these days.
I moved to Texas in 2005 and eventually got my shop set up so it was time to do some reloading. When I was changing calibers to reload 9mm, I discovered that I did not have the correct primer feed tube. I e-mailed Dillon Precision and got a phone call from one of their techs. Long story short, they sent me what I needed at no charge!

Dillon Precision has a whole line of terrific products and they have the absolute best warranty in the business. I recommend them to everyone!

-- Matt Davis  

Dillon Precision RL-550B Progressive Reloading Machine
$265

Available from and manufactured by Dillon Precision